Receivers

No more pulling out the antenna! With this handy bolt fit Tube Clamp. Note - Please use smaller M3 Bolt if fowling of cable is apparent.

Specifications

• Length: 31mm
• Width: 20mm
• Height: 13mm

SPECIFICATION:

• Channel: 6CH Receiver
• Receiver size (L/W/H): 35x20x13mm
• Receiver operating current: 30mA
• Receiver voltage range: 3.3-10V
• Supports high voltage servos
• Water-proof
• Stable distance control up to 200 meters
• Suitable for "CR6S" / CR4S-EVO / SR6S-EVO

Only for ET111 radio

GTXE CARBON SERVO & RECEIVER CASE HOLDER - FLAT CHASSIS

RX8E GRAPHITE RECEIVER CASE HOLDER

CONNECTING CABLE RECEIVER/BATT. PACK

ALU ECCENTRIC MOUNT FOR RECEIVER BOX

ALU MOUNT FOR RECEIVER BOX

COMPOSITE ONE-PIECE SPEEDO PLATE & RECEIVER BOX

GRAPHITE RECEIVER CASE TOP PLATE

GRAPHITE RECEIVER CASE TOP PLATE

XB808E GRAPHITE RECEIVER CASE TOP PLATE

RECEIVER SWITCH - SET

GRAPHITE RECEIVER BRACKET SET

RUBBER RECEIVER CASE COVER

COMPOSITE RECEIVER CASE - COMPACT SIZE

COMPOSITE RECEIVER CASE - V2

Sold as seen

This is the all-new RC4WD Warn 1/10 Advanced Wireless Remote/Receiver Winch Controller Set. It is Officially Licensed by Warn Industries and features an On/Off switch with LED indicator, lanyard strap, and a 1:1 detailed remote design with rubber buttons for improved operation.

Specifications

Remote

• Over 50ft Range
• Batteries Included
• Total Length: 2.10in / 53.5mm
• Total Width: 1.06in / 27mm
• Height: 0.59in / 15mm
• Weight: 0.49oz / 13.9g
• On/Off Switch

Receiver

• Small Compact Size
• Operating Voltage 6V to 11.1V
• Easy Plug and Play
• Instruction Included
• Length: 1.6in / 40.4mm
• Width: 1.2in / 30.2mm
• Height: 0.37in / 9.4mm
• Weight: 0.5oz / 14g

Wires

• Length: 6.0in / 150mm
• Wires Weight: 0.14oz / 4g

Lanyard

• Total Length: 7.24in / 184mm
• Weight: 0.14oz / 1.8g

What's Included

• 1 x WARN 1/10 Wireless Remote
• 1 x Wireless Receiver Unit
• 1 x 6" Battery/Receiver Power Wire
• 1 x 6" Receiver/Winch Control Wire
• 1 x Lanyard
• 1 x Warn Decal Sheet

Notes

• This Receiver on this product is waterproof but the Controller is not. You may be able to waterproof on your own but this will void the manufactures warranty.
• Tampering with this product in any way would result in voiding the warranty.
• Binding process can take 3-5 seconds.
• Some LiPo battery voltage can be higher than 11.1 volts. Please be careful and check voltage before using your battery. Use a BEC if needing to use a 3 cell LiPo.
• The remote comes with a 3V CR2025 button cell.