Receivers - Instock

Sold as seen

Features:

• For ESC

• Material: Metal

• Color: Black

• For use with all 1- 2S ESC from Stock to Modified classes.

• Orca’s ONPC is one of the smallest and lightest of such capacitors in the market.

• Orca’s ONPC provides the best of both size and performance to give you the extra edge over your competition.

Specification:

• Size: 20.5mm x 16mm x 6.9mm

• Weight: 7.4g

• Max Voltage: 16V

• Capacity: 1700uF (36pcs)

• Item no: 2020025
• Model: R10WP
• HF-Frequency: 2.4 GHz FHSS 
• Channels: 10
• Waterproof: Yes
• Input power: 4.8–10 V/DC
• Weight: 10g
• Size: 40*27*13mm 

Glitch Bluster Power Capacitor Plug

Or use 2S (7.4v) 8.4V ESC, remove voltage protection, then use 1S (3.2v) 4.2V lipo instead via this module, still giving 6v to the receiver. Or in applications where the ESC has no 6V BEC output. 

1S DC-DC BOOSTERs, DC-DC power booster modules which can draw power from the 1S LiPo battery then boost it to the voltage level (6V) suits the receiver & servo and provide the continuous output current up to 3A, are mainly applied in 1/12 RC vehicles. Nowaday 1/12 cars usually use 1S LiPo batteries, and BECs in ordinary ESCs are step-down. In that case, the BEC output voltage will be lower than 4.2 V that cannot meet the power demand of the receiver & servo. Therefore, 1/12 cars have to run with purpose-built 1S ESCs installed in or external receiver batteries connected if speed controllers are common. No other solutions. However, things will be different after adopted this booster. Then the receiver battery can be abandoned and users can be free from charging and maintaining batteries.

Receiver as supplied with the MX-6.
Model: RX-391W
Frequency: 2.4GHz FHSS-E
Input Voltage: 4.8v ~ 7.4v
Weight: 12.4g
Dimensions: 24.0 x 37.0 x 18.2 mm
Fail Safe Support: Yes - Throttle

ET0785

Winch Speed Controller unit for the RC Overhaul Winch unit (CR002). Connect this speed control unit to a spare channel in your receiver to operate from a spare channel on your transmitter.

If you use a separate power source then you will need to remove the red positive wire from the receiver plug.

Only for ET111 radio